Not a trapdoor but close- Miller Conversion of Parker Snow musket

[Dick Hosmer]

Happy to help! I've met Ed a couple of times - nice guy, and extremely knowledgeable.

[carlsr]

A couple pictures

IMG_20230722_121505.jpg (239.92 KiB) Viewed 296660 times

IMG_20230722_121405.jpg (242.93 KiB) Viewed 296660 times

IMG_20230722_121344.jpg (229.52 KiB) Viewed 296660 times

[carlsr]

IMG_20230722_121426.jpg (181.16 KiB) Viewed 296659 times

A few more

IMG_20230722_121452.jpg (237.23 KiB) Viewed 296659 times

IMG_20230722_121325.jpg (145.05 KiB) Viewed 296659 times

[carlsr]

Last one

IMG_20230722_121523.jpg (156.72 KiB) Viewed 296659 times

[John S.]

I modified the title of this thread to better identify the topic.

[throck3]

Thanks for posting these photos! I never really knew too much about the Miller Conversion. The photos answer a lot of questions, especially to why it was never seriously considered by the Ordnance Board. It appears as if would be very complicated to manufacture.

Rick T

[Dick Hosmer]

Thanks for posting these photos! I never really knew too much about the Miller Conversion. The photos answer a lot of questions, especially to why it was never seriously considered by the Ordnance Board. It appears as if would be very complicated to manufacture.

Rick T

Good point, but I'm not sure the 1st Allin was any better, though it certainly looked sleeker - the Miller is kind of ugly, though I suspect it might have been a stronger action. In any event, its' extractor lived on - and the government finally had to pay for the design.

[carlsr]

Thanks for posting these photos! I never really knew too much about the Miller Conversion. The photos answer a lot of questions, especially to why it was never seriously considered by the Ordnance Board. It appears as if would be very complicated to manufacture.

Rick T

You’re welcome Rick T
I feel the action is less complicated than the 1st Allin. The Miller design has less moving parts and doesn’t require those 2 little screws to hold the ejector and ejector lever together, which by the way are not available anywhere. So if you have a 1st Allin I suggest not removing those screws as they break rather easily, I have experience there

[carlsr]

I modified the title of this thread to better identify the topic.

Thanks John although I thought my title left a little mystery

[carlsr]

Thanks for posting these photos! I never really knew too much about the Miller Conversion. The photos answer a lot of questions, especially to why it was never seriously considered by the Ordnance Board. It appears as if would be very complicated to manufacture.

Rick T

Good point, but I'm not sure the 1st Allin was any better, though it certainly looked sleeker - the Miller is kind of ugly, though I suspect it might have been a stronger action. In any event, its' extractor lived on - and the government finally had to pay for the design.

The extractor the government eventually paid on was on the 2nd variation pictured here.
I always thought that there was only one design but apparently they somewhat copied Allin's design

IMG_20230723_120058.jpg (152.18 KiB) Viewed 296628 times