.22LR Conversion

[bobATL]

I picked up an 1873 Trapdoor with the barrel sleeved to .22 caliber and an adapter to fit a .22 cartridge in the .45-70 chamber. Very quiet. I only got one adapter which is inconvenient as sometimes the cartridge deforms enough that it has to be removed with pliers so I'm not going to get a high rate of fire. Anybody familiar with this conversion?

IMG_1128.JPG (132.3 KiB) Viewed 2242 times

IMG_1127.JPG (161.4 KiB) Viewed 2242 times

[bobATL]

Front sight dovetailed to barrel.

IMG_1142.JPG (184.93 KiB) Viewed 1531 times

[bobATL]

Front sight dovetailed to barrel.

IMG_1142.JPG (184.93 KiB) Viewed 1574 times

[bobATL]

View into the chamber.

[Kragrifle]

No, but that is really neat!

[25ring]

That's a Lee Shaver 22rf liner conversion. A lot of BPCR use it in their cartridge rifles. I have one installed in one of my Trapdoors.

[bobATL]

My eyes find the sights difficult but still got a fairly good grouping with the Trapdoor. Fired several rifles today that all hit right of center so the wind may have had some effect. I found that anything more powerful than 22CB deforms the cartridge enough that it sticks in the adaptor and has to be pulled out with pliers. Recoil and noise are non-existent.

IMG_1645.JPG (85.64 KiB) Viewed 146 times

[Dick Hosmer]

Would be fun to conjecture ways to reverse engineer that thing to provide better head support so as to allow use of .22LR, even including knocking the case out with a rod. I'd also think that use of a fencing musket mainspring would reduce the massive overkill of the normal hammer blow.